1/10/2024 0 Comments Cadworx add data table categoryIf the system is not using a CADWorx P&ID setup configuration file, the additional fields are obtained from the DATABASE.TBL file located in the \Plant\System folder. When using a P&ID project, changes made to a line number configuration within CADWorx reflect within the P&ID project. Click Add in the Category group in this dialog box to select additional fields located in the process lines table of a typical P&ID project database. You can change the configuration file location in SETUP to use the same project configuration as any P&ID project. This system also works with a CADWorx P&ID setup configuration file. For more information, see LineNumberSystem. Static line numbering is also useful when selecting runs of piping for other functions with CADWorx. Static is useful when all components and sizes of a particular piping run are required to have the same line number (such as, the 3/4″ vent on an 8″ process line needs a line number of 8″-150-2001-N). In the static mode, you must manually change the size and specification. In the dynamic mode, CADWorx adjusts the line number according to the size or specification. If the system is on, it can operate in a static or dynamic mode. You can turn the line numbering system on or off. Plant menu: Accessory > Line Numbers > Setup
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |